Looking for a Photo of wiring loom on firewall AND going down to the frame rail

[Haasman]

As the subject says- looking for a photos of wiring loom on firewall AND how it goes down to the frame rail. Trying to see how to route the wiring loom.
I have found a lot of pictures of just the firewall with the loom, but I am looking for how the wiring loom is attached and is routed to the frame.

BTW, I just discovered this site. Wonderfully helpful. Thank you!

Jeff aka Haasman

[Deve]

I do not have a good clear one. Once it goes through the metal clamp/loops (the three on the lower firewall) I do not have an original truck available to tell you exactly. Leave a little slack so the movement of the cab on the frame doesn't pull on the wires. I went directly from those clamps to the front of the master cylinder bracket and down the frame rail. I did use an original truck for it, but I cannot guarantee if the wiring was original. Sorry I can't be more help. Anyone who has an original truck that can snap a few pictures, please do.

[Haasman]

Thanks Dave

-anyone with pictures of lower firewall & wiring loom?

[Haasman]

Here are some firewall wiring pictures. The beautiful yellow truck should be familiar to everyone.
Haasman